I-View AnyNet-0401Mini Embedded NVR - Manual (Page 44)

44
Section 6:
Alarm Tolerance – You can define the acceptable movements to prevent false alarms movements.
For example, if the tolerance is set to 2, the movements in the video must be occurred at least three
consecutive times to trigger alarm and start to record this video channel.
Post recording – You can set the duration to continue recording after motion is no longer detected.
If the duration is between one motion detection occurrence and a subsequent motion detection
occurrence, the two instances will be combined into one alarm/recording session.
Pre-alarm - The camera will start a new motion triggered recording session at least 1~99 seconds in
advance when the event occurs. The pre-alarm recording video will save into the HDD with about 2
FPS recording rate speed.
Section 7:
Actions to take upon motion detection: This section will allow you to set up what the NVR
software should act when the motion detection is triggered. Please refer to the introduction below
for setup details:
Exit without saving
your audio selection.
Record your voice
message via your
PC’s microphone.
Halt the current
playing session.
Save your audio
selection and exit the
setting
Select an audio file
for alarm siren.
Play a siren or your
voice message.