Lexibook DJ040 Series - Manual (Page 15)

1 1
ENGLISH
Click “Install AP” on the “Digital
Camera Install Menu” window and
select a language from the drop down
list.
INSTALLING A MEMORY CARD
Please refer to image C.
Your digital camera has a built-in memory of 16MB (2 pictures or 20 seconds
of video). You may also insert a SD card (2GB maximum, not included) to
increase the memory size of the camera.
1. Turn the camera off, then open the door of the battery compartment.
2. Push the SD card firmly into the slot located below the batteries until you
hear a “click” sound. The icon will be displayed after inserting an SD card
and powering the unit on.
3. Close the battery door.
Note:
• When an external memory card has been inserted in the camera, all the
photos/videos taken will be stored on the external memory card.
• To remove the card, push it in slightly to release it from the slot.
• The SD card must be FAT-formatted to be used with your digital camera.
Use your computer to format the card. The formatting process may vary
according to your computer operating system. Refer to the instructions
provided with your computer and/or the SD card for detailed information.
IMPORTANT NOTE: It is highly recommended to add a SD card to
increase the storage capacity of the unit.
INSTALLING THE SOFTWARE AND THE CAMERA DRIVER
Follow these instructions to install the “PhoTags Express” and “Webcam
Express” software and the camera driver on your computer system.
1. Insert the CD Software (included) in your CD-ROM drive. The CD will auto
run, and the installation menu will appear.
DJ040seriesIM0119.indd 15 16/3/09 10:46:59