Lexibook DJ030 Series - Manual (Page 11)

10 11
ENGLISH
GETTING TO KNOW YOUR CAMERA
Please refer to image A.
1. SD card slot
2. Shutter/Set button
3. Flash
4. Camera lens
5. USB connector port
6. Up/Flash button
7. Optical viewfinder
8. Power/Menu button
9. LED
10. LCD display
11. Battery compartment
12. Down/Playback mode button
INSERTING NEW BATTERIES
Please refer to image B.
1. Make sure the camera is off.
2. Using a screwdriver, open the battery compartment cover located at the
back of the unit.
3. Insert 2 x LR03/AAA 1,5V type batteries (not included) observing the
polarity indicated at the bottom of the battery compartment.
4. Close the battery compartment and tighten the screw.
Note: When the “low battery” icon flashes on the LCD screen, replace
the batteries.
Non-rechargeable batteries are not to be recharged. Rechargeable
batteries are to be removed from the product before being charged.
Rechargeable batteries are only to be charged under adult supervision.
Different types of batteries or new and used batteries are not to be
mixed. Only batteries of the same or equivalent type as recommended
are to be used. Batteries are to be inserted with the correct polarity.
Exhausted batteries are to be removed from the product. The supply
terminals are not to be short circuited. Do not throw batteries into a fire.
Remove the batteries if you are not going to use the product for a long
period of time.
WARNING: Mal-function or loss of memory may be caused by strong
frequency interference or electrostatic discharge. Should any abnormal
function occur, remove the batteries and insert them again.
Important note: all the files stored into the unit’s internal memory will be
lost when switching off the camera or replacing the batteries. Make sure you
transfer the files to your computer before turning off the product or changing
the batteries.
DJ030seriesIM0109.indd 11 16/3/09 10:45:25