Actiontec GT701D Installation Guide User Manual

Actiontec Routers

Advertising
background image

Note: The DSL light may blink.

Note: If the Ethernet Light does NOT turn green, make sure the Yellow Cable is
properly connected on both ends.

1

Connect the Modem to a Computer

Step

1

Get the DSL Modem

from your DSL Quick Start Kit and
take it out of the bag.

Step

4

Plug the larger end of the

Power Cord into a Power Outlet.

Step

5

Make sure the Power Light on

the Modem is SOLID

Green

.

Step

6

Get the Yellow Cable

.

Step

7

Plug one end of the Yellow

Cable into the Yellow Port on the
back of the DSL Modem.

Flip this Quick Start Guide over to continue

NEXT

Power
Outlet

Power

Cord

Step

9

Make sure that the Ethernet

light on the Modem is

Green

. This may

take a few moments.

Yellow Port

Yellow
Cable

Step

10

Get the Black or Gray DSL

Cable from your DSL Quick Start Kit.

Step

11

Plug one end of the DSL

Cable into the Gray Po rt located on
the back of the Modem.

Step

8

Make sure that your com-

puter is turned on. Then, plug the
other end of the Yellow Cable
into the Ethernet Port on the
back of the computer.

An Ethernet Port looks similar to
a regular Phone Jack, but is
slightly larger.

Step

12

Plug the other end of the

DSL Cable into the Phone Jack closest
to your computer.

Gray Port

Black
Cable

example of a typical inline

phone filter

Phone
Port

Black
Cable

Step

13

Make sure All Devices with

the same phone number as your DSL
Line have Phone Filters. This includes
telephones, fax machines, caller ID
boxes, satellite TV receivers, TiVo
devices, and answering machines.

Note: Your Power Cord may look different.

Step

2

Get the Power Cord from

your DSL Quick Start Kit.

Step

3

Plug the smaller end of

the Power Cord into the Black
Port
on the back of the Modem.

Power
Cord

Black
Port

Note: If the DSL Light continues to blink, make sure you received notification
from your DSL Internet Service Provider that your DSL service has been activated.

Step

14

Make sure that the Power

and DSL Lights are solid

Green

. This

may take up to 30 seconds.

GT701D QS12_GT704WG QS7.qxd 11/1/11 4:45 PM Page 1

Advertising