C.E. Niehoff & Co. N7485 DE Housing Replacement Instructions User Manual
N7485 drive end housing on
Advertising
N7485 Drive End Housing on
CEN P/N N1506-1
Field Replacement Instructions
Figure 1 — Through-stud Removal
When replacing the drive end housing on the N1506-1 alternator, follow Figure 1 to remove the
proper through-stud on drive end of shell/stator/fi eld coil assembly.
The new N7485 drive end housing has molded B+ studs and will require the through-stud shown in Figure 1
to be removed to fit the new housing.
Use caution when removing through-stud to prevent damaging stator windings.
CAUTION
II0107A
T
T
Remove this through-stud ONLY
Page 1 of 2
Go to Page 2 and Figure 2 to set new drive end housing in position.
T
T
Position center
drain hole facing you
Advertising