Castle TSM-35 Operator Manual User Manual
Page 26
CASTLE, INC
TSM-35 OWNERS MANUAL V1.2
Page 26 of 33
Router Carriage:
The Router Carriage is the red weldment located inside the
machine and holds the Router Spindle and motor in place. This
carriage is mounted to the machine with the upper two Jacking
Screws which can be found on the side of the machine (one on
each side). The carriage is moved back and forth through the rout
cycle by a Drive Cylinder which links the carriage to the Web
Adjustment Plate.
Drill Carriage:
The Drill Carriage is the yellow A-frame weldment inside the
machine, to which the Sioux air drill is mounted. This carriage is
mounted to the machine with the lower two Jacking Screws which
can be found on the side of the machine (one on each side). The
carriage is moved back and forth through the drill cycle by the Drive
Cylinder, which anchors the carriage to the Safety Pallet.
Router Spindle Assembly:
The Router Spindle Assembly is attached to the red Router
Carriage, and is what spins the router bit. This spindle has a small
pulley on the bottom which connects, via a flat rubberized belt, to
the large pulley on the motor.
Control Box:
The Control Box is a gray sheet metal enclosure that houses the
electrical controls of the machine: Transformer, Overload,
Contactor, Control Board, and Pressure Switch. Mounted to the
back side of the Control Box are all the pneumatic valves that
control the function of the machine’s cycle.