Castle TSM-20 Operator Manual - Manual (Page 3)

TSM-20 Operator’s Manual 1
1.0 GETTING STARTED
1.1 Warning
The Castle Tool Mortise Machine was designed with operator safety as a priority. DO NOT ATTEMPT
TO OPERATE THIS MACHINE UNTIL ALL INSTRUCTIONS HAVE BEEN READ.
1.2 Check for Damage
Your Castle Tool Mortise Machine was carefully prepared for shipment at our factory. Upon receipt at
your plant, carefully inspect the machine for damage. Immediately report any damage to the freight
company, your dealer, and Castle, Inc.
1.3 Package Contains
Warranty Card (Must be returned for warranty activation)
Operator’s Manual
Router Wrenches (4)
Bit Gage
Model TSM-20 Mortise Machine
1.4 Requirements
110 V AC, 20 AMP Power Supply
Air Source (80 psi minimum)
2.0 GLOSSARY OF TERMS
The major components of the model TSM-20 and a brief description of their functions are as follows:
2.1 Carriage
The carriage is the orange A-Frame structure inside the machine. Both the router and the drill motors are
mounted to this carriage. There are also two micro switches mounted at the top of the carriage. The micro
switch mounted towards the rear of the machine stops the travel of the carriage during its routing cycle
and starts the drilling cycle. The micro switch mounted towards the front of the machine stops the travel
of the carriage during the drilling cycle.