Atek electronic Super MiniTM - Manual (Page 7)

INSTALLATION
•
If you are using the USB port, it is not necessary to turn
off your computer before plugging the mouse into the
USB port on your computer or into a USB hub. If you
are using the PS/2 port, you must first shut down your
operating system and turn off your computer before
plugging the mouse into the PS/2 port on your
computer. Also make sure you disconnect any mouse
that is currently connected to the PS/2 port or to the
serial port.
•
Locate the USB or PS/2 port on your computer. A USB
port is a flat rectangular port. A PS/2 port is a round
mini-DIN port.
•
Plug the mouse connector into the USB port on the
computer, or plug the mouse connector into the USB-
PS/2 adapter and then plug the adapter into the PS/2
port on the computer. Make sure the orientation of the
connector is correct – do not force the connector into
the port.
•
Please note that the Super Mini™ Optical Mouse does
not work with a serial (DB9) port and Atek does not
support the use of active signal converters such as
USB-serial converters.
6