AEG LAVAMAT 47380 - Manual (Page 26)

User information
26
Operating problems
Many checks have been carried out during the manufacture of your
washing machine. However, if you face a problem with its operation,
please read the following sections before calling the After Sales
service.
Symptom Cause
The washing machine will
not start or will not fill • the washing machine is not correctly
connected, the electrical installation is
not working,
• the cover of your washing machine
and the drum flaps are not correctly
closed,
• you did not control the program start
correctly,
• there is a power failure,
• the water supply is closed off,
• the water tap is closed,
• the water inlet is blocked.
The washing machine fills
up but empties again
immediately • the drain siphon is attached too low
(see installation section).
The washing machine will
not spin or will not empty • the drain pipe is blocked or kinked,
• the drain filter is blocked,
• the anti-unbalance mass safety device
has tripped; bad distribution of
washing in the drum,
• the «Drain» program or the «Rinse hold»
option is selected,
• the height of the drain siphon is
wrong.