ASA Electronics LCM1042TV - Manual (Page 7)

5. TV / VIDEO BUTTON
Any video equipment connected to the AUDIO/
VIDEO inputs can be used with the TV by pressing
this button. Each time the button is pressed, the
Audio/Video source will change in the following
sequence VIDEO 1, VIDEO 2 and TV.
6. MUTE BUTTON
Press this button to turn TV sound off. Press again
to restore sound to the previously set level. Mute
may also be released by pressing the VOLUME +/-
buttons.
7. SKIP / SEARCH BUTTON
This button selects between SKIP and SEARCH
mode. In “SKIP mode” the TV only stops on
channels that are programmed into memory when
the CHANNEL UP/DOWN buttons are pressed.
When SKIP is turned off, the TV will advance to
next channel/previous channel number when
channel up/down is pressed.
8. ERASE / WRITE BUTTON
When tuned to a channel, press this button to store
or erase the channel from memory. The stored
channel numbers are displayed in green on the
screen, and the non-stored channels are in red.
Remote Controlled TV Functions
1. POWER ON/OFF
Press this button to turn the LCM1042TV on. The
channel number or current video source will be
displayed on screen, and the picture will appear in
a few seconds. Press the button again to turn the
LCM1042TV off.
2. DIRECT ACCESS (0-9) BUTTONS
Use these buttons to make a direct channel
selection. The channel number chosen will be
displayed on the screen for about 4 seconds. To
select channels 0-99, press two number buttons.
For example, to select channel 8, press 0, 8. To
select channels above 100, press the 1-- button,
then the number buttons for the last two digits of
the channel. For example, to select channel 115,
press 1--, 1, 5.
3. CHANNEL UP/DOWN BUTTONS
Use these buttons to advance to the next higher or
lower channel.
4. PIX AND VOLUME UP/DOWN BUTTONS
To raise or lower the volume level. Also used to
adjust the picture control setting when “contrast”,
“bright”, “color” or “tint” is displayed on – screen.
-7-