Axis Communications 232D - Manual (Page 13)

AXIS 231D/232D Installation Guide Page 13
ENGLISH
Accessing the AXIS 231D/232D from the Internet
Once installed, your AXIS 231D/232D is accessible on your local network (LAN). To access the
camera from the Internet, network routers must be configured to allow incoming traffic, which
is usually done on a specific port. Please refer to the documentation for your router for further
instructions.
For more information on this and other topics, please visit the Axis Support Web at
www.axis.com/techsup
Resetting to the Factory Default Settings
This will reset all parameters, including the IP address, to the Factory Default settings:
1. Disconnect power from the camera.
2. Press and hold the Control button and reconnect power.
3. Keep the control button pressed until the Power Indicator flashes amber (this may take
up to 15 seconds).
4. Release the control button.
5. When the Power Indicator displays green (which can take up to 1 minute) the process is
complete and the camera has been reset.
6. Re-install the AXIS 231D/232D using one of the methods described in this document.
More information
For more information, please see the AXIS 231D/232D User’s Manual, which is available from
the Axis Web site at: http://www.axis.com