J&M 385SD-D - Manual (Page 11)

11
GRAVITY BOX LIGHT INSTALLATION GUIDE
GRAVITY BOX LIGHT KIT PARTS LIST
# Part # Description Qty
1 7-WCE 7-Wire Connector End 1*
2 7-WNB 7-Wire Nose Box 1*
3 WH-1 Main Wiring Harness 1*
4 LH-1 Light Harness 1
5 AB-1F Front Angle Bracket 1
6 AB-1R Rear Angle Bracket 1*
7 LE-1B Light Enhancer 1
8 LT-R1 Red Light 2
9 LT-A1 Amber Light 2
10 PG-1L Plastic Grommet 1
11 RD-A1 Amber Reflective Decal 6
12 RD-R1 Red Reflective Decal 2
13 RD-O1 Orange Reflective Decal 2
14 141-CB 1/4" x 1" Carriage Bolt 12
15 14-FN 1/4" Flange Nut 12
16 181-HB 1/8" x 1" Hex Bolt 2
17 18-HN 1/8" Hex Nut 2
18 1434-SDST 1/4" x 3/4" Self-Tapping Screw 7
19 WLC-1 Wire Loom Clamp 3
20 SMV-2 Slow Moving Vehicle Emblem 1
21 WHB-1 Wire Harness Storage Bracket 1
22 RCW-1 Rubber Cap for Bracket 1
23 OFL-1 Flood Light 1
24 OMSC-1 OM Storage Container 1
25 141CB 1/4" x 1" Carriage Bolt 4
26 14WN 1/4" Whiz Nut 4
27 WG-2 Wire Guard for Rear Lights 2
28 RL-1AB Replacement Lens (amber) ---
29 RL-1RB Replacement Lens (red) ---
* Assembled as one unit
IMPORTANT: Position the SMV Emblem with a point of
the triangle upward and as near to the rear and centered
or as near to the left of center of the unit as practicable.
The SMV Emblem should be located two to ten feet above
the ground measured from the lower edge of the emblem.
SECURING THE WIRE HARNESS STORAGE
BRACKET
Place the wire harness storage bracket against the
front face of the gravity box. Secure the bracket
using two 1/4” x 3/4” Self-Tapping Screws. Slide
the Rubber End Caps over each end of the Wire
Harness Storage Bracket. Securely wrap the Main
Wiring Harness around the bracket for storage. To
prevent injury, do NOT secure the storage bracket
along the side of the ladder.
#27
Wire Guard for
Rear Lights
1/4” x 1” Carriage
Bolt and Flange
Nut