J&M 540SD - Manual (Page 11)

Pg. 11
GRAVITY BOX LIGHT KIT REPAIR PARTS LIST
# Part # Description
1 7-WCE 7-Wire Connector End
2 7-WNB 7-Wire Nose Box
3 WH-1 Main Wiring Harness
4 LH-1 Light Harness
7 LE-1B Light Enhancer
8 LT-R1 Red Light
9 LT-A1 Amber Light
10 PG-1L Plastic Grommet
11 RD-A1 Amber Reflective Decal
12 RD-R1 Red Reflective Decal
13 RD-O1 Orange Reflective Decal
14 141-CB 1/4” x 1” Carriage Bolt
15 14-FN 1/4” Flange Nut
16 181-HB 1/8” x 1” Hex Bolt
17 18-HB 1/8” Hex Nut
18 1434-
SDST
1/4” x 3/4” Self-Tapping Screw
19 WLC-1 Wire Loom Clamp
20 SMV-2 Slow Moving Vehicle Emblem
21 WHB-1 Wire Harness Storage Bracket
22 RCW-1 Rubber Cap for Bracket
23 OFL-1 Flood Light
IMPORTANT: Position the SMV Emblem with a point of the
triangle upward and as near to the rear and centered or as
near to the left of center of the unit as practicable. The SMV
Emblem should be located two to ten feet above the ground
measured from the lower edge of the emblem.
PARTS LIST
SECURING THE WIRE HARNESS
STORAGE BRACKET
Place the wire harness storage bracket against the front
face of the gravity box. Secure the bracket using two 1/4” x
3/4” Self-Tapping Screws. Slide the Rubber End Caps over
each end of the Wire Harness Storage Bracket. Securely
wrap the Main Wiring Harness around the bracket for
storage. To prevent injury, do NOT secure the storage
bracket along the side of the ladder.
# Part # Description
24 OMSC-1 Owners Manual Storage Container
25 141CB 1/4” x 1” Carriage Bolt
26 14WN 1/4” Whiz Nut
27 WG-2 Wire Guard for Rear Lights
28 RL-1AB Replacement Lens (amber)
29 RL-1RB Replacement Lens (red)