J&M GW15t-1 - Manual (Page 14)

GC15
t
-1 G
ravity
W
aGon
a
ssembly
-14-
Begin to assemble the 16 Ton Running Gear. Start by sliding the Coupling Pole Weldment through
the Rear Axle and the Retaining Ring. Use a 1” x 6-1/2” Hex Bolt and a 1” Centerlock Hex Nut to
attach the Retaining Ring and Coupling Pole Weldment to the Rear Axle.
STEP - 26
STEP - 25
Install the Wire Wrap Bar. Use (2) 1/4”-20 x 3/4” self tapping screws to install the bar. Self tap your
first screw at the labeled dimension. Do not tighten the screw all of the way. Now level the wire-
wrap bar to the ground. Install the last screw. Completely tighten both self tapping screws.