J&M 275ST - Manual (Page 17)

14
1.0 Operations
2.1 Grease Conveyer/Auger Bearings
Grease the conveyor/auger bearings every 10 hours of operation and before storage. Use only two pumps of
grease per bearing (Figure 2.1).
NOTE: Over lubrication of these bearings will result in premature failure.
NOTE: The conveyor has four bearings that need grease (two at each end). The auger is equipped with
one bearing (at hopper end).
2.2 Grease Boom Arm
Grease pivot points on boom arm every 50 hours and before storage (Figure 2.2).
2.0 Service
Figure 2.1
Grease Point
Grease Points
Figure 2.2