J&M 1151-22D - Manual (Page 28)

26
SET-UP INSTRUCTIONS
Roll Tarps for Grain Carts
1
Center the lock panel from the front to the rear of
the cart on the off auger side of the cart. Make
sure that the lock panel is flush to the inside of the
sideboard. Holes may already be pre-drilled for the
installation or may need drilled out with a 1/4” drill
bit. Use a pair of vise grips to temporarily hold the
lock panel to the off auger side of the cart. Bolts
will be used in a later step that will secure the lock
panel.
Bolt together each of the end caps using 1/4”-20 x 1/2” hex
head bolts and 1/4”-20 serrated flange hex nuts. One end cap
will have a windlip sticking up and the other will be sticking
down. The endcap that has the 1” windlip sticking up is the
front endcap. On the front end cap leave the last four holes
empty on the opposite auger side. Use four 1/4”-20 x 5/8”
hex head bolts and four 1/4”-20 serrated flange hex nuts to
attach the plastic rail piece at the last four holes to the end-
cap assembly. The end cap that has the 1” lip in the opposite
direction of the rib is the rear end cap arch. This should be
paired up with the end cap plate that has three to four extra
holes in it (holes for the J-bolts) and is shorter.
Use four 1/4”-20 x 3/4” hex bolts, four 1/4”-20 centerlock
hex nuts, five 3/8”-16 x 1” serrated flange hex bolts and five
3/8”-16 serrated flange hex nuts to attach each of the end
caps. The end cap is pre-drilled, however, 1/4” holes may
need drilled through the top of the sideboards and 3/8” holes
may need drilled through the endboards to match the end-
caps hole pattern. Once this is completed, drill and install
one more 1/4”-20 x 5/8” hex head bolt at the end of the front
end cap through the plastic rail piece and a 1/4-20 x 1/2” at
the other end of the same end cap with no plastic rail piece.
2
1/4” x 1/2” 1/4” x 5/8”
1/4” x 5/8”
Drilled and
i n s t a l l e d
after end cap
is bolted to
Grain Cart.
Plastic Rail Piece
1/4” x 3/4”
3/8” x 1”
Install the two piece prop-up bars in the front and
rear of the Grain Cart. Install the Lower Portion of
the Bow Prop with one 3/8” x 1” Serrated Flange
Hex Bolt and one 3/8” Serrated Flange Hex Nut to
the rear brace first (holes may not be pre-drilled for
this). Then, pushing up on the end cap, attach the
Top Portion of the Bow Prop to the Bottom Por-
tion of the Bow Prop with two 3/8” x 1” Serrated
Flange Hex Bolt and two 3/8” Serrated Flange Hex
Nut so that the Two Piece Prop-Up Bar is pushing
the end cap upwards to keep from sagging.
3
Two Piece Bow
Prop holding up
the end cap.
Top Portion of
the Bow Prop
Lower Portion of
the Bow Prop
Installing the Lock Panel (Drip Edge)
Installing End Caps and Plastic Rail
Installing Bow Prop on Endcaps
Lock panel placed
on Opposite
Auger Side.