J&M 1325-20D - Manual (Page 32)

DIGI-STAR Autolog for Grain Carts
SET-UP INSTRUCTIONS
To complete the installation of the Digi-star Autolog system on a grain cart drive shaft:
First remove the drive shaft cover guard located on the backside of the middle bearing on
the drive shaft (detail 1).
The drive shaft cover tube (detail 5) can now be cut back six inches from the end closest to
the front of the cart.
After the drive shaft cover tube has been cut back, the supplied screw clamp (detail 6) can
be installed on the drive shaft as indicated in the Digi-star Autolog manual.
After the drive shaft cover tube has been removed the sensor bracket can be installed on the
upper passenger side bolt in the bearing (detail 2).
Once the bracket is in the proper location the sensor can be installed in the hole closest to
the bearing side of bracket (detail 3), using caution to not install the sensor too close to the
drive shaft. The sensor depth must be set to the proper distance having a 1/8” air gap from
the screw clamp screw as indicated in the Digi-star Autolog manual. This can be done by
using the two supplied jam nuts (detail 4) to adjust this gap.
To secure the sensor in the bracket tighten the two supplied jam nuts (detail 4) on the sensor
(detail 3) down adequately to prevent the movement of the sensor in the bracket.
Secure the wires so that they aren’t hanging where debris can damage them. Once the brack-
et and sensor is installed properly reinstall the drive shaft cover guard removed in step 1.
For more detailed installation instructions see the included Digi-star Autolog manual to
complete this installation.
1)
2)
3)
4)
5)
7)
8)
INSTALLATION CONTENTS
QTY-1—25 Foot Rotation Counter “Y” Cable (PN: 407201)
QTY-1—Rotation Counter Sensor (PN: 407199)
QTY-1—Rotation Counter Mounting Bracket (PN: 403014)
QTY-1—Steel Sensor Target with Adhesive (PN: 407419)
QTY-1—Steel Sensor Target Screw Clamp (PN: 407389)
30