J&M HT-874XL-36 - Manual (Page 11)

11
SET-UP INSTRUCTIONS
Place extension bracket at rear end of Upper Bar. Attach using the two angle iron supports and secure with
four 1/2” x 5” bolts, washer and nuts.
Place Light Mounting Bracket at the end of the Extension Bracket Arm so the Light Mounting Bracket is level
or horizontal and extends towards the center of the header transport. Secure using two 1/2” x 1 1/4” Flange
Bolts (Gr 5) and Flange Nuts.
Slide the extendable portion of the Telescoping Arm into Light Mounting Bracket and tighten the Handle Nut
until the bracket is secure. Extend the arm until the light assembly is within 16” of the outer extremity of the
unit.
Mount one light assembly at the end of the Light Mounting Bracket (L/H light) and another assembly at the end
of the Telescoping Arm (R/H light). Secure each light assembly using four small self-tapping screws. Each
light assembly should be mounted so the single amber light is positioned towards the outside of the header,
and the amber and red lights are facing the rearward. Secure the SMV Emblem to the Light Mounting Bracket
using two 1/4” x 1” Bolt and Lock Nuts. Be sure the SMV Emblem remains visible from the rear during
transport.
Place one amber reflective decal at the outward and front side of both the Telescoping Arm and Light Mounting
Bracket as shown. Place one Red and Orange Reflective Decal on the rearward end of the Telescoping Arm
and Light Mounting Bracket. The red reflective decal should be place directly above the orange decal.
Slide the Main Wiring Harness through the rubber grommets of the tongue and into the Upper Bar until the
harness extends through the back end of the Upper Bar. Connect the Main Wiring Harness to the corresponding
plug on the Light Enhancer. Attach the smaller Light Wiring Harness to the remaining plug on the Light
Enhancer. Connect each set of wires on the Light Wiring Harness to each Light Assembly. Securely place the
Light Enhancer and excess wiring inside the Upper Bar to prevent damage from weather or operation.
Place the Wire Clip around the Main Wiring Harness and secure to the rear side of the front axle using the large
self tapping screw provided. Be sure the wiring harness is secured properly to avoid any possible pinch points.
Place the remaining Amber Reflective Decals on the Header Transport as indicated below:
SIDE
VIEW
TOP
VIEW
16’ Maximum Spacing 16’ Maximum Spacing 16’ Maximum Spacing
One Amber
Decal must
be as
rearward as
practical
(each side)
One Amber Decal must be
within 16’ of the hitch point
of the transport (each side)
One Red
above One
Orange
Reflective
Decal (each
side)
SMV Emblem
Amber
Decal
Amber
Decal
Amber
Decal
Amber Decal
(visible from front)
Amber
Decal
Amber Decal
(visible from front)