J&M Storm Tracker 2 Track system (2011 & newer) - Manual (Page 7)

7
Routine Maintenance
WARNING: When Servicing The Track System, Be Certain All Power To Grain Cart Is Shut Off.
Repack the wheel bearings at least once a year. Use Bearing Gard MK1 or equivalent lubricant. Also check the
seal for wear and replace if necessary.
Check the track system periodically for cracks in welds and for other structural damage. Have cracked welds
fixed immediately. Failure to do so could result in extensive damage to the track system and grain cart and great-
ly reduce the life of the equipment.
Lubricate the track system according to the Lubrication Service Schedule.
Make sure that all guards and shields are in place before operating the track system.
Check the pressure in the air spring after every 100 hours of operation and at the beginning of each season. The
correct air pressure is 100 psi.
Check the wheel hubs and make sure the nuts are torqued to 350 ft. lbs. Check the hub nuts after the first
hour of operation, then every 10 hours of operation for the first 40 hours of use. These nuts must be kept
tight at all times. Wheels that are improperly installed and maintained, resulting in failure, will nullify the
warranty and shift the burden of liability to the owner/operator of the equipment.
TROUBLE SHOOTING
WARNING: Make sure all power is shut off to grain cart before servicing the track system. Maintenance and
repair service work to be performed by qualified servicemen only.
Trouble… Possible Causes… Possible Remedy…
Belt Guide Lugs Show Wear Misalignment Adjust Front Alignment Weldment
No Belt Tension Deflated Air Spring Replace Air Spring (100 psi max.)