Arizona Picdem 17 User Manual
Picdem™ 17 demonstration board user’s guide
Advertising
Table of contents
Document Outline
- Title
- Table of Contents
- Chapter 1. About PICDEM 17 Demonstration Board
- Chapter 2. Using the PICDEM 17 Monitor
- Chapter 3. Hardware Description
- Chapter 4. Using the MPLAB® C17 C Compiler
- Chapter 5. LCD.C Description
- Chapter 6. USART.C Description
- Chapter 7. ANALOG.C Description
- Chapter 8. SWITCH.C Description
- Chapter 9. I2C.C Description
- Appendix A. PICDEM 17 Demonstration Board Schematics
- Appendix B. RS-232 Communication Protocol
- Appendix C. Floppy Disk Contents
- PREFACE
- Chapter 1. About PICDEM 17 Demonstration Board
- 1.1 Introduction
- 1.2 Highlights
- 1.3 Processor Sockets
- 1.4 External FLASH Memory
- 1.5 Memory Mapping
- 1.6 Power Supply
- 1.7 Prototyping Areas
- 1.8 Oscillator Options
- 1.9 RS-232 Serial Ports
- 1.10 Push-button Switches
- 1.11 LEDs
- 1.12 Analog Circuitry
- 1.13 External LCD Interface
- 1.14 CAN Bus Interface
- 1.15 24LC01B Serial EEPROM
- 1.16 Modular Connectors
- 1.17 Pre-programmed Sample
- Chapter 2. Using the PICDEM 17 Monitor
- 2.1 Introduction
- 2.2 Highlights
- 2.3 Installing the PICDEM 17 Monitor Program
- 2.4 Using the PICDEM 17 Monitor Program
- 2.5 Resetting the PICDEM 17 Demonstration Board
- 2.6 Erasing the FLASH on the PICDEM 17 Demonstration Board
- 2.7 Downloading HEX Files to the PICDEM 17 Demonstration Board
- 2.8 Running HEX files from the PICDEM 17 Demonstration Board
- 2.9 Running Diagnostics on the PICDEM 17 Demonstration Board
- 2.10 Modifying Memory Contents
- Chapter 3. Hardware Description
- Chapter 4. Using the MPLAB® C17 C Compiler
- Chapter 5. LCD.C Description
- Chapter 6. USART.C Description
- Chapter 7. ANALOG.C Description
- Chapter 8. SWITCH.C Description
- Chapter 9. I2C.C Description
- Appendix A. PICDEM 17 Demonstration Board Schematics
- Appendix B. RS-232 Communication Protocol
- Appendix C. Floppy Disk Contents
- Worldwide Sales