Alpine CDA-7832R - Manual (Page 11)

20
English
Basic Operation
Turning Power
On and Off
1
Press the PWR button to turn on the unit.
Note: The unit can be turned on by pressing
any other button except the eject c
button.
The volume level gradually increases to the
previous level you were listening to before the
unit was turned off. Press the PWR button
again to turn off the unit.
1
1
Subwoofer On and Off
Use the Subwoofer Output when a non-fading
signal would be most effective. For example, to
drive an amplifier with a low-pass filter.
Press and hold the Eject button for at least 3
seconds.
With each press, Subwoofer is toggled On or
Off.
Notes:
•
Initial mode is "SUBW OFF."
•
Leave the "SUBW OFF" as long as the
Subwoofer output is not being used.
•
When the subwoofer is turned on, the
subwoofer output level can be adjusted. For
more details, refer to the Adjusting Volume/
Bass/Treble/Balance/Fader section on page
24.
1
SUB-W ON
SUBW OFF
INTLZ
PWR