Avaya Cajun P550 - Manual (Page 23)

Cajun P550/P880 Manager User Guide
Configuring the Cajun Switch Using the P550/P880 Manager
2-15
■
All ports in a hunt group must be the same speed.
■ Packets arriving on different fabric ports within the switch
have more evenly balanced loads.
■ Hunt groups do not load share if the source and destination
traffic and the hunt group ports are on the same fabric port.
Most I/O modules divide their ports evenly across two fabric
ports. For 10-port and 12-port I/O modules, all ports use a
single fabric port.
■
The first port assigned to a hunt group becomes the flood
port. It can not be changed unless the flood port is disabled.
Hunt Groups in the Cajun P550/P880 Manager
Using the Cajun P550/P880 Manager, you can launch the Hunt
Group Configuration dialog box of the Cajun Switch Web Agent. In
this dialog box, you can complete any of the following tasks:
■ Creating a Hunt Group
■ Viewing Hunt Group Members
■ Adding a Port to a Hunt Group
■ Deleting a Hunt Group
■ Redistributing Hunt Group Learned Addresses
For information about the Hunt Group Configuration dialog box
and associated tasks, refer to “Using VLANs, Spanning Tree, and
Hunt Groups (Layer 2 and Layer 3)” in the Cajun P550/P220 Switch
Operations Guide.
Creating a Hunt Group
To create a hunt group:
1. Start Cajun P550/P880 Manager. For information about
starting the Cajun P550/P880 Manager, refer to "Starting the
Cajun P550/P880 Manager" earlier in this chapter.
2. Select Tools > Link Aggregation.
Or
From the tool bar, click Link Aggregation.