Hunter 53207 52 Avignon - Manual (Page 8)

www.HunterFan.com
1.888.830.1326
Motor Housing
Canopy
Screw
Canopy
Screw
Rubber
Plug
Place the fan housing over the motor. Align
the keyholes in the fan housing with the
two partially installed canopy screws in the
hanger bracket. Rotate the fan housing to
situate the screws in the end of the keyholes.
The motor housing is not secured until
the next step is complete. Do not leave
unattended.
Keyhole
Keyhole
Install the two remaining canopy screws,
found in the hardware bag, into the
holes in the fan housing and into the
hanger bracket. Tighten all four screws
securely. Install the rubber plugs, found in
the hardware bag, into the holes over
the canopy screws.
8
M3505-01 • 01/07/13 • © Hunter Fan Company