Hunter 59141 52 Morelli - Manual (Page 13)

www.HunterFan.com
1.888.830.1326
13
M3552-01 • 05/14/14 • © Hunter Fan Company
Light Kit
Partially install two of the switch housing
screws found in the bag. Connect
the plugs from the upper and lower
switch housings. Make sure to line up the
colored markings on the connectors.
Align the keyhole slots in the light kit
housing with the switch housing screws.
Make sure all the wires from the fan and
the light kit are snug inside the center of
the light kit, not pinched in between the
upper switch housing and the light kit or
hanging out of the sides.
Turn the light kit counterclockwise until
the switch housing screws are firmly
situated in the narrow end of the keyhole
slots. Install the remaining screw into the
housing. Tighten all three screws securely.
Switch
Housing
Screw
Make sure the light kit is securely attached to the upper
switch housing. Failure to properly secure all three assembly
screws could result in the light fixture falling.