Hunter 53026 52 Woodford - Manual (Page 15)

www.HunterFan.com
1.888.830.1326
Light Kit (continued)
CONGRATULATIONS!
YOU’RE DONE!
Install a bulb into each of the
sockets. When necessary, replace
with bulbs of same wattage.
See next page for fan
operation instructions.
Connect the appropriate pull
chain pendant to each of the
short chains coming from the
switch housing.
Note: In compliance with US federal energy regulations, this ceiling fan
contains a device that restricts its light output. Exceeding the wattage
limit marked on the MAX wattage sticker affixed to the light socket(s)
may result in fire hazard or improper operation.
Fan
Pull
Chain
Light
Pull
Chain
Bulb
Make sure the lower switch housing is securely attached to
the upper switch housing. Failure to properly secure all three
assembly screws could result in the light fixture falling.
Place the globe over the threaded
lampholder then install and hand
tighten the threaded lock washer
onto the lampholder.
Globe
Lampholder
Lock washer
M3513-01 • 01/31/13 • © Hunter Fan Company
15