Hunter 23949 48 Forest Hill - Manual (Page 10)

10
42693-01 • 05/14/10 • Hunter Fan Company
5-1 . IMPORTANT! Before you change the Jumper
settings, make sure the battery is not connected
to the transmitter . Change the position of the
jumpers in the transmitter and the DIP switches
in the receiver . Be sure the position of the jumper
in the transmitter matches the position of the DIP
switches in the receiver . If they don’t match, the
controller will not function . For instructions on how
to set the jumpers, read the box below .
5-2 . Install the included 12-volt battery into the
transmitter .
Setting DIP switches and Jumpers
When two or more fans are located near each other, you
may desire to have the receiver/transmitter for each fan
set to a different code, so that the operation of one fan
does not affect the operation of the other fans .
The DIP switches for the receiver are located on the flat
surface of the receiver . The Jumpers for the transmitter
are in the the battery compartment .
CAUTION: The remote control device complies with part 15 of
the FCC rules . Changes or modifications not expressly approved
by Hunter Fan Company could void your authority to operate this
equipment .
Operation is subject to the following two conditions:
1 . This device may not cause harmful interference .
2 . This device must accept any interference received, including
interference that may cause undesired operation .
Note: Use with a fan that incorporates an air gap switch (normal on-
off wall switch) .
WARNING: Maximum fan load is 1 Amp; maximum lamp is 300
Watts . Do not use any speed control with this product .
You must now set the jumpers in the remote
transmitter and DIP switches in the receiver so that
they match .
4 3 2 1
4 3 2 1
4 3 2 1
4 3 2 1
4 = off (apagado)
3 = on (encendido)
2 = on (encendido)
1 = on (encendido) 4 = off (apagado)
3 = on (encendido)
2 = off (apagado)
1 = on (encendido)
Example Jumpers Settings
Receiver 1 Receiver 2
Transmitter 2 Transmitter 1
4 3 2 1
4 3 2 1
4 3 2 1
4 3 2 1
4 = off (apagado)
3 = on (encendido)
2 = on (encendido)
1 = on (encendido) 4 = off (apagado)
3 = on (encendido)
2 = off (apagado)
1 = on (encendido)
Dip Switches
Set to 01110
Dip Switches
Set to 01001
Dip Switches
Set to 01110
Dip Switches
Set to 01001
Receiver 2 Receiver 2
Example DIP Switch Settings
DIP Switches
Set to 0111
DIP Switches
Set to 0100
DIP Switches
Set to 0100
DIP Switches
Set to 0111
Transmitter 1 Transmitter 2
Receiver DIP
switches
Remote
Transmitter
Jumper Switches
5 • Setting the Remote Transmitter and Receiver