ADT Security Services 3000 - Manual (Page 26)

– 26 –
3DJLQJ)HDWXUH
$ERXW$XWRPDWLF3DJLQJ
Your system may be set up to automatically send alert messages to a pager as certain
conditions occur in your system.
•
The following events can be programmed by your installer to send a message to
up to four pagers: arming, disarming, alarms, and trouble conditions.
•
You can also program the system to send an automatic pager message to alert
you in the event that someone has not arrived home (disarmed the system)
within a defined period of time (see the Scheduling section for details on
programming a “latch key report”).
•
Your installer programs the pager phone numbers and reporting events.
•
The pager message consists of a 7-digit system status code that indicates the
type of condition that has occurred.
•
An optional, predefined 16-digit character string can precede the 7-digit system
status code; these characters can consist of a PIN no., subscriber account no., or
any additional data that you may wish to have sent to the pager.
•
The pager display format is as follows:
3-digit Event Code
И И
Optional 16 digits Ж Ж AAAAAAAAAAAAAAAA – BBB – CCCC Е Е 4-digit User or Zone No.
A = B = C =
Optional 16-digits for
Account numbers,
PIN numbers, or any
other data;
programmed by the
installer, if required. A 3-digit code that
describes the event
that has occurred
in your system
(see for event
codes table below)
A 4-digit User or Zone number, depending on the type of
event that has occurred, where:
•
alarms and troubles display zone number
• arming/disarming (opens/closes) display user number
The first 2 digits are always “00” (e.g., 0004 represents
zone or user number 4), and, single-digit user or zone
numbers are always preceded by a zero.
The 3-digit Event Codes (BBB) that can be displayed are:
911 = 811 = 101 = 102 =
Alarms.
The 4-digit number
(CCCC) following this
code is the zone number
that has caused the
alarm.
Troubles.
The 4-digit number
(CCCC) following this
code is the zone number
that has caused the
trouble.
Open
(system disarmed).
The 4-digit number
(CCCC) that follows
this code is the user
number that has
disarmed the system.
Close
(system armed).
The 4-digit number
(CCCC) that follows
this code is the user
number that has armed
the system.
Examples of typical 7-digit pager displays follow.
Ex. 1 .
 ³
= R eporting of an alarm (911) caused by a fault on zone 4 (0004).
Ex. 2.
³ 
= Reporting of a closing–system arming (102)– by user 5 (0005).