CHIEF SL151 Series - Manual (Page 9)

Installation Instructions SL151
9
NOTE: If installing the SL151 in a drywall ceiling, remove the
outside terminal block and cover with plate (C), using
four 6-32 x 3/16" Phillips pan head screws (F).
Wiring Options
NOTE: Refer to Table 1: Wiring Table and (See Figure 16) for
information on all wiring options.
NOTE: Refer to Table 2: Terminal Descriptions and (See
Figure 16) for terminal descriptions, functions and
wiring options.
Re-Attaching Ceiling Panel
1. Line up rectangular holes in ceiling panel with clips on ends
of rods, and re-attach the ceiling panel. (See Figure 14)
CAUTION: Damage to equipment could result if clips are
not lined up properly with rectangular holes.
Figure 14
2. Carefully insert clips into rectangular holes in ceiling panel.
3. Reattach guide wires (two places) to ceiling panel, using
screws removed earlier. (See Figure 15)
Figure 15
Rectangular
Holes
Clips
x 2
Ceiling
Panel
Guide
Wire