CHIEF FDP Series - Manual (Page 5)

Installation Instructions FDP Series
5
INSTALLATION
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
IMPORTANT ! : These instructions assume that a 1-1/2"
to 2" O.D. pipe (not included) has been properly installed
in either a vertical or horizontal position.
(Optional) Latching Flag Placement
The latching flag may be moved as necessary.
1. Remove Phillips head screw, Nylock nut and latching flag
attached to the FDP (A). (See Figure 1)
Figure 1
2. Re-position latching flag and tighten using Phillips head
screw and Nylock nut. (See Figure 1)
FDP Bracket Assembly and Installation
The FDP includes tilt brackets that can be repositioned to
attach to vertical or horizontal pipes. The FDP assembly ships
configured for vertical pole mounting. To change the FDP for
horizontal pole mounting, use the following instructions. To use
the FDP in the vertical configuration, proceed to Vertical
Installation section.
Horizontal Installation
1. Remove eight tilt adjustment screws (four from each tilt
bracket). (See Figure 2)
2. Detach tilt brackets from FDP (A). (See Figure 2)
3. Reposition the tilt brackets as shown. (See Figure 2)
Figure 2
1
(Nylock nut)
(A) x 2
(Latching flag)
2
(B) x 8 1
(Tilt brackets)
(A) x 2
2
3