CHIEF MCD Series - Manual (Page 7)

Installation Instructions MCD Series
7
Adjusting Roll
1. Loosen the Nylock roll adjustment nut on back of mounting
plate. (See Figure 6)
2. Tilt the faceplate left or right as required.
3. Tighten nut.
NOTE: Do NOT over tighten fasteners.
Adjusting Pitch
1. Adjust display to the desired pitch.
2. Tighten the pitch adjustment screw to hold mount in
position. (See Figure 6)
Figure 6
Roll
Adjustment
Pitch
Adjustment
Screw
Nut