CHIEF FHP110, FHPV - Manual (Page 6)

FHP110, FHPV Installation Instructions
6
2. Install two M4 x 12mm Phillips pan head screws (L) into
upper mounting holes in display back leaving 3/16” of screw
protruding out of display.
3. Align screws in display back with upper mounting holes in
Centris cup until screws are seated in lower area of
mounting slots.(See Figure 3)
4. Place Centris cup against display back and install two
M4 x 12mm Phillips pan head machine screws (L) through
lower mounting holes in Centris cup and into lower
mounting holes in display back.
Figure 3
5. Secure display to mount by tightening the four M4 x 12mm
Phillips pan head screws (L). (See Figure 3)
6. Install and secure power cables to display, allowing enough
slack for easy movement of display. (See Cable
Management section.)
7. Proceed to Attaching Assembly Columns.
VESA Compliant Recessed Mounting
WARNING: IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Using screws of
improper size may damage your display. Properly sized
screws will easily and completely thread into display
mounting holes. If spacers are required, be sure to use longer
screws of the same diameter.
1. Install four .50 x .194 x 3/8" nylon spacers (P) or four
.50 x .194 x 3/4” Nylon spacers (Q) as necessary over the
mounting holes of your recessed display. (See Figure 4)
Figure 4
2. Install mount over spacers, aligning hole pattern on display
with hole pattern on mount.
3. Secure mount to your display using either:
• four M4 x 20mm Phillips pan head screws (N) for
1/2” x 3/8” nylon spacer installation, or
• four M4 x 30mm Phillips pan head screws (M)
for the 1/2” x 3/4” nylon spacer installation
4. Install power cables, allowing sufficient slack for easy
movement of display. (See Cable Management section.)
TOP
5
Display
(L) x 4
Inner column
Centris cup
(P or Q) x 4
Centris cup
(N or M) x 4 3
1