CHIEF PF2 Series User Manual

Page 7

Advertising
background image

Installation Instructions

MF1, MF2, PF1, PF2 Series

7

5.

Gather stand base pieces B and C (2) as shown in Figure 4
and push them together until the edges meet.

Figure 4

6.

Place top base section and center post assembly on top of
the three base pieces with the center post front facing base
pieces (C). (See Figure 5)

7.

Fasten lower base pieces (B and C) to top base section and
center post assembly using twelve 5/16-18 x 1/2" flat head
cap screws (L). (See Figure 5)

Figure 5

Assembling Base for Dual Display Stand

CAUTION:

INNER COLUMN IS SHIPPED DISENGAGED

and may pinch hands! Hold both inner and outer posts
(columns) while removing from box.

IMPORTANT ! : Press cable tie tab to loosen and
remove cable tie from around knob post. (See Figure )

NOTE:

Disengage knob on center post BEFORE attaching

base to center post.

1.

Follow Steps 1-4 (and Figures 1, 2 and 3) of Assembling
Base for Single Display Stand.

2.

Gather four base pieces (C) as shown in Figure 6 and push
them together until the edges meet.

Figure 6

3.

Place top base section and center post assembly on top of
the four base pieces. (See Figure 7)

4.

Fasten lower base pieces to top base section and center
post assembly using twelve 5/16-18 x 1/2" flat head cap
screws (L). (See Figure 7)

Figure 7

(B)

(C)

(B)

(C)

(L) x 12

4

(F)

(Front)

(C) x 4

(C) x 4

4

(L) x 12

(F)

Front

Advertising
This manual is related to the following products: