CHIEF PFQ - Manual (Page 7)

Installation Instructions MFM, PFM, MFQ, PFQ
7
ASSEMBLY
CAUTION: Attachment holes may be damaged if a power
drill is used to insert button head cap screws. Screws should
first be inserted and turned BY HAND with the hex key or with
a handheld screwdriver BEFORE using the hex head drill
bit (Q) and power drill to complete the attachment.
Assembling Cart
1. Assemble two legs (A) and (B) to the cart cross bracket (E)
using two 5/16-18x4-1/4" button head cap screws (N) and
one end cap (F) per leg. (See Figure 1)
Figure 1
CAUTION: Attachment holes may be damaged if a power
drill is used to insert button head cap screws. Screws should
first be inserted and turned BY HAND with the hex key or with
a handheld screwdriver BEFORE using the hex head drill
bit (Q) and power drill to complete the attachment.
NOTE: Insert and turn screws in order shown (1, 2, 3, 4) in
Figure 2.
Figure 2
2. Attach center post (C or D) to leg assembly using four
5/16-18 x 2-3/4" button head cap screws (M) and four 5/16"
washers (P). (See Figures 2 and 3)
Figure 3
3. Attach head assembly (G) or (H) to the cart assembly using
four 5/16-18 x 3/4" button head cap screws (L).
(See Figure 4)
Figure 4
(Front view of cart)
(N) x 4
(F) x 2
(B)
(E)
(A)
1
(Bottom view of cart)
1
2
3
4
(Front view of cart)
(M) x 4
(P) x 4
(C) or (D)
2
(Back view of cart)
(MFM Shown)
(G) or (H)
(L) x 4
(C) or (D)
3