CHIEF STROTR - Manual (Page 5)

Installation Instructions WROTR and STROTR-30/-36/-42
5
INSTALLATION
1. Remove and SAVE two screws from ST-/WROTR base (A)
front and remove the cover plate. (See Figure 1)
Figure 1
2. Slide top of base forward, exposing bottom of base. (See
Figure 2)
3. Attach ST-/WROTR base to mounting surface using
fasteners (not included) which are appropriate size and type
for the mounting surface. (See Figure 2)
4. Slide top of base back to cover the bottom of base.
Figure 2
5. Replace cover plate and attach with two fasteners removed
in Step 1. (See Figure 1)
ASSEMBLY
NOTE: Do not tighten fasteners until all top and shelves have
also been installed.
1. Loosely assemble side mounting plate (G) to base side
using three fasteners (D - for WROTR; E - for STROTR).
(See Figure 3)
2. Repeat for other side mounting plate.
Figure 3
3. Loosely assemble top (B) to side mounting plates (G) using
three fasteners (D - for WROTR; E - for STROTR) on each
side. (See Figure 4)
Figure 4
1
x 2
cover plate
1
5
5
(WROTR shown)
Mounting
holes
2
3
4
(WROTR shown)
(D or E) x 3 1
(G)
2
(STROTR shown)
(D or E) x 3 3
(G)
(G)
(B)
(STROTR shown)