CHIEF NW1 Series - Manual (Page 6)

NW1 Racks Installation Instructions
6
ASSEMBLY
NOTE: The NW1 rack may be assembled so that the hinge is
located on either the left or the right.
Assembling Rack Sections
1. Attach the rack center section (B) to the rack rear section
(A) using two 3/8-16 x 2" socket head cap screws (E). (See
Figure 3)
Figure 3
Latch Catch
2. Insert appropriate latch catch [left or right (G or H)] into slot
in NW1 rack and adjust latch catch so that holes in latch
catch match up with holes in rack. (See Figure 4)
3. Attach latch catch using two 08-32 x 3/8" Phillips pan head
screws (D). (See Figure 4)
Figure 4
Rubber Bumpers
4. Add rubber bumpers (F) to front of rack rear section (A) on
side opposite the hinges. (See Figure 5)
Figure 5
1 (E) x 2
(A)
(B)
(Left latch catch (G) shown)
(G)
3 (D) x 2
(G)
2
4 (F) x 2
(A)
[Alternate
location of
rubber
bumpers]