CHIEF FSA1013 - Manual (Page 5)

Installation Instructions FSA1013
5
3. Position Laptop so that it is centered and resting against the
front edge of tray. (See Figure 5)
Figure 4
4. Push slide trays inward until slide tabs rest against side of
laptop. (See Figure 5)
5. Tighten two locking thumbscrews on tray bottom.
Figure 5
6. Loosen two slide tab retaining screws. (See Figure 6)
7. Position slide tabs so they are not blocking any ports on
laptop. (See Figure 6)
8. Tighten two slide tabs. (See Figure 6)
Figure 6
ADJUSTMENTS
Tray Pitch Adjustment
To adjust the tray vertical position:
1. Loosen tray pitch adjustment screw by turning screw
counter-clockwise using 3/16" hex wrench.
2. Reposition tray.
3. Tighten tray pitch adjustment screw by turning clockwise
using 3/16" hex wrench.
Figure 7
Front Edge
Locking Thumbscrews
Slide Tabs
Slide Tabs
Slide Tab Retaining Screw
(two places)
Slide Tab
(two places)
Pitch Adjustment Screw