CHIEF FCA100 - Manual (Page 3)

Installation Instructions FCA100
3
INSTALLATION
NOTE: The FCA100 may be used to support a surge adapter
or other components that don’t exceed the weight
capacity of the FCA100.
1. Put Velcro tabs (C) together so there are 4 squares of
Velcro.
2. Remove paper from one side of each of the four Velcro
squares.
3. Attach Velcro squares to the left and right brackets
(A and B). (See Figure 1)
Figure 1
4. Remove paper from Velcro squares and press the surge
adapter, or other component, against the left and right
brackets.
NOTE: Rest the surge adapter on the inside legs of the
brackets.(See Figure 2)
Figure 2
5. Place the left and right brackets with the surge adapter onto
the wall mount. (See Figure 3)
NOTE: The brackets may be placed on either the upper or
lower wall mount rail.
Figure 3
(A) (B)
3 (C) x 4
4
Inner
Legs
5
Brackets may be placed on
upper or lower rail
5