CHIEF PAC501 User Manual
Page 6
PAC501
Installation Instructions
6
2.
Cut four 8" long support blocks out of 2" x 4" wood.
3.
Using three #10 x 2-1/2" countersunk wood screws (not
provided), attach each support block to the studs (See
Figure 2)
NOTE:
Ensure screws are far enough from block end to
prevent interference with framing screws installed in
Step 6.
4.
If necessary, cut rectangular hole in horizontal framing to
accommodate the PAC-GB1 Listed electrical box accessory
(not included).
5.
Attach horizontal framing to each support block with two
#10 x 2-1/2" countersunk wood screws (not provided).
(See Figure 2)
In-Wall Enclosure Installation
1.
Install PAC-GB1 Listed electrical box accessory (not
included) into the PAC-501 (A) following instructions
included with the PAC-GB1.
2.
Connect electrical wiring according to National Electrical
Code(NEC) ANSI/NFPA 70 - 2008, wire connection
requirements.
3.
Route audio/visual cables into housing.
4.
Center PAC-501 (A) in opening and insert into opening.
Align front of box with front face of wall. (See Figure 3)
Figure 3
WARNING:
ELECTRICAL SHOCK HAZARD!
CUTTING
OR DRILLING INTO ELECTRICAL WIRES OR
CABLES CAN CAUSE DEATH OR SERIOUS
PERSONAL INJURY!
ALWAYS make certain area behind
mounting surfaces is free of electrical wires and cables
before cutting, drilling, or installing fasteners.
5.
Drill four 3/16" diameter pilot holes in studs at side mounting
holes. (See Figure 4)
6.
Attach the PAC-501 (A) to side studs using four M7 x 50mm
Allen head connector screws (D) and mounting spacers (B)
using an M4 Allen head drill bit (E). (See Figure 4)
Figure 4
NOTE:
The PAC-501 has 1/2" total clearance between the two
studs. The spacers allow side to side adjustment.
7.
Drill eight 3/16" diameter pilot holes in horizontal framing at
top and bottom mounting holes. (See Figure 5)
8.
Attach the PAC-501 (A) to horizontal framing using eight
M7 x 40mm Allen head connector screws (C) using an M4
Allen head drill bit (E). (See Figure 5)
Figure 5
Mounting
(A)
x
5
6
x 4
(D) x 4
(B) x 4
8
(C) x 8
7
x 8