CHIEF PAC780-782-784 - Manual (Page 8)

PAC780/782/784 Installation Instructions
8
2. Reattach faceplate on top of gas spring assembly plate.
IMPORTANT ! : When attaching faceplate ensure that
the ClickConnect lock is at TOP of head assembly, and
bracket tabs slide into the cart/stand assembly. (See
Figure 13)
Figure 13
3. Fasten through faceplate and gas spring assembly plate
using four 5/16-18 x 1" button head cap screws (C). (See
Figure 14)
Figure 14
4. Position removed base of cart/stand to reattach to column.
5. Install four button head cap screws and washers (removed
at beginning of assembly/installation) through holes in cart/
stand, gas spring assembly base (A) and into outer column
of cart/stand. (See Figure 15)
IMPORTANT ! : Partially install each screw until gas
spring is compressed before tightening screws.
Figure 15
6. Stand cart/stand in upright position. Inner column should be
fully extended.
7. Pull down inner column to desired height.
ClickConnect
lock
3 (C) x 4
Faceplate Gas spring
assembly plate
Column
(cart shown)
back of outer column
base of cart/stand
removed
removed
5
(A)
washers
screws
(cart shown)