CHIEF PAC716 - Manual (Page 6)

PAC716 Installation Instructions
6
Camera Mounting
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all equipment and accessories mounted on the PAC716 does
not exceed 10 lbs (4.54 kg).
NOTE: Mounting options will vary depending on the type of
camera being mounted.
1. Install 1/4-20 x 3/8" Phillips pan machine screw (F) through
one of the mounting holes on shelf and into the hole on the
bottom of the camera. (See Figure 4)
NOTE: Camera can be secured to mount by threading a strap
(not included) through outside slots on camera mount
and around the camera.
NOTE: It is also acceptable to mount the camera directly to the
shelf using the hook and loop squares (D) provided.
Figure 4
Adjustments
Height Adjustment
1. Loosen two adjustment knobs on the back of the PAC716
shelf (A). (See Figure 5)
2. Raise or lower shelf to desired height. (See Figure 5)
3. Tighten two adjustment knobs on the back of the shelf until
mount is secure. (See Figure 5)
Figure 5
Shelf Extension Adjustment
1. Loosen two button head cap screws on PAC716 shelf (A).
(See Figure 6)
2. Adjust shelf to desired mounting position. (See Figure 6)
3. Tighten two button head cap screws on shelf until mount is
secure. (See Figure 6)
Figure 6
Strap
(not included)
camera (example)
1 2 3
2
(A)
1 2 3
2
(A)