CHIEF ROTRS - Manual (Page 4)

ROTRS Installation Instructions
4
ASSEMBLY
1. Attach shelf brackets (B) to ROTRS shelf (A) using four #4-
40 x 1/4" pem studs (C) and four #4-40 lock nuts (D). (See
Figure 1)
NOTE: Brackets may be installed anywhere on shelf where
there are mounting slots based on user preference.
Figure 1
2. Use four 1/4-20" lock nuts (E) and four 1/4-20 x 1/2" pem
studs (F) to secure shelf to ROTR rack at desired mounting
height. (See Figure 2)
IMPORTANT ! : Shelf can only be mounted using larger
diameter holes in ROTR rack rails. Pem studs will not fit
through the smaller holes.
Figure 2
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located within the rack does not exceed 250
lbs (113.4 kg). Use with products heavier than the maximum
weight indicated may result in instability or collapse of the
rack causing possible injury.
3. Install desired components to shelf.
(A)
(B) x 2
(C) x 4
1 (D) x 4
2 (E) x 4
(F) x 4
ROTR