CHIEF QMP1T - Manual (Page 5)

Installation Instructions QMP1T
5
ASSEMBLY
The QMP1T is designed to be attached to the Chief QMP1FB
fixed music stand or the QMB1MB mobile music cart.
1. Attach column to cart/stand base (not included) following
instructions included with cart/stand (not included).
2. Attach table bracket (C) to attachment plate (E) using one
10-24 x 1/2" Phillips undercut machine screw (H), two 10-24
x 3/8" button head cap screws (J), two #10 flat washers (N),
and four 10-24 nylon lock nuts (M). (See Figure 1)
Figure 1
3. Fasten table brace (D) to bracket assembly using four 10-24
x 3/8" button head cap screws (J). (See Figure 2)
Figure 2
4. Fasten the table top (F) to the table bracket assembly using
six #10 x 5/8" Phillips wood screws (L). (See Figure 3)
Figure 3
5. Fasten the table top assembly to the cart/stand using four
1/4-20 x 3/4" button head cap screws (K) through two array
clamps-inner (B) or two array clamps-outer (A). (See Figure
5)
Figure 4
2 (J) x 2
(H) x 1
(N) x 2
(M) x 4
(C)
(E)
2
(D)
3 (J) x 4
Bracket assembly
(L) x 6
4
(F)
Table bracket
assembly
(Back of column - QMP1FB/
QMP1MB)
5 (K) x 4
(A or B) x 2
Table top
assembly
[B shown]