ALLIED Vision Technologies Bonito CL-400 200 fps User Manual
Page 73
Appendix
Bonito Technical Manual V2.3.0
73
| | 7 -> 19200 Baud. (x)
| | 8 -> 38400 Baud. (x)
| | 9 -> 57600 Baud. (x)
| | A -> 115200 Baud. (x)
| +---------a: Second channel UART port selection.
| 00 -> Second channel UART off.
| 01 -> Activate second channel via Camera
| Link connector O2 (or CL1).
| 10 -> Activate second channel via Camera
| Link connector O4 (if available).
| 11 -> Activate second channel via Camera
| Link connector O2 (or CL1) and O4.
+-----------e: Echo suppression.
0 -> Each character received from the host
is echoed back to it.
1 -> No echo.
Command and Parameter Overview - User Mode (Upper Case)
-------------------------------------------------------
A=<p16> : Start value for line address counter A. It sets the line
address of the image's first line read out from the
image sensor. After processing each line the address is
incremented by the amount specified by I=<p8>. See N=<p16>
for number of lines per image. Valid range 0...6BF (decimal:
0...1727).
B=<p16> : Start value for line address counter B. It sets the line
address of the second ROI's first line read out from the
image sensor. After processing each line the address is
incremented by the amount specified by I=<p8>. See N=<p16>
for number of lines per image. This parameter is only used
in double ROI mode. Please see command D=<p8> for
details. Range 0...6BF (decimal: 0...1727).
C=<p8> : Mode and control of the fixed pattern noise (FPN) correction.
Please note that correction data is volatile and has to
explicitly be acquired at least once after switching on the
camera.
<****_**sm>
||
|+-m: Mode of fixed pattern noise correction.
| 0: No correction is applied.
| 1: Acquire new fixed pattern noise correction
| data and apply it to the image. To
| successfully complete the procedure ensure
| continous image output by e.g. setting
| M=0. For optimum quality please totally
| darken the sensor during data acquisition.
| Avoiding bright light sources might also
| be sufficient, but a residual image may
| occur. Please note that saving the
| correction state with X=<p8> will activate
| the correction at start of the camera
| without correction data. This leads to an
| uncorrected image until new correction
| data has explicitly been reacquired.