Avaya 03-300686 - Manual (Page 129)

C360 converged stackable switches
Issue 3 January 2008 129
●
Do not allow anything to rest on the power cord. Do not locate this product where the cord
will be abused by persons walking on it.
●
Do not overload wall outlets and extension cords as this can result in the risk of line or
electric shock.
●
Disconnect the cords on this product and refer servicing to qualified service personnel
under the following conditions:
●
If the power supply cord or plug is damaged or frayed.
●
If liquid has been spilled into it.
●
If it has been exposed to rain or water.
●
If it was dropped or the housing has been damaged.
●
If it exhibits a distinct change in performance.
●
If it does not operate normally when following the operating instructions.
Using the C360 switch
The C360 Stackable Switch can be used to power 46xx series IP telephones in addition to
providing a 10/100 megabits per second Ethernet connection. The switch can form part of a
stack with the G700 Media Gateway or members of the P330 stackable switching system.
A C360 stack can contain up to 10 switches and up to three backup power supply units. The
stacked switches connect using the stacking submodules that plug into a slot in the back of the
C360. The X330RC cable connects the top and bottom switches in the stack and provides
redundancy and hot-switchability. This characteristic is similar to how modules can be swapped
in a modular switching chassis.
Avaya C360 switches are multilayer switches and can be upgraded with a license to provide
routing (Layer3) functionality.
The C360 switches can be mounted in a standard 19-inch (48-centimeter) rack or mounted on a
wall.