Audiovox P-153 - Manual (Page 14)

-14-
CD CHANGER ERROR CODES
INDICATION CAUSE SOLUTION
E-01 Disc elevator
malfunction
Press EJECT button to eject the disc magazine. Once ejected, reinsert
the magazine.
E-02 Disc loading
malfunction
Press EJECT button to eject the disc magazine. Once ejected, reinsert
the magazine.
E-03 Eject malfunction Press the EJECT button and retry ejecting the magazine.
E-06 Disc drive
malfunction
Press the play button to start disc play. If this fails to start disc play,
eject and reinsert the disc magazine.
E-08 Focus malfunction The disc may be damaged or dirty or may be inserted upside-down in the
magazine. Remove the disc magazine and check/clean/replace the disc.
b appears after the track number on the display. The chosen
selection of the track or tracks will repeat over and over until the
RPT A-B button is pressed again. RPT and b disappear from the
display.
er
PROGRAM CD TRACKS (PGM/MEM CLR)
During disc play, the programming function can select up to 24
CD tracks to play in any order. Program works by allowing you
toselect a track number for each spot in the playing sequence.
To begin programming, select a desired track number on the disc
by using the TUNE TRACK button; this initiates an up/down scan
of the CD tracks.
When the desired track is found, press the MEM/CLR button for
less than 1 second to enter the track number into memory. M --
01 will appear on the display. Repeat this procedure for each of the
other 23 selected tracks in the desired order. M -- 02-24 will appear
on the display.
To play CD tracks in the programmed order, press the PGM but-
ton. PGM will appear on the display, and the tracks on the CD(s)
will play in the desired order.
To clear the programmed CDtracks, press the MEM CLR button
for more than 3 seconds. M -- CL will appear on the displayand
the programmed tracks will be erased.