Datamax-O'Neil H-Class Powered Internal Rewind Option - Manual (Page 7)

5
B) Load Media as you normally would, but extend
about 20 inches (50 cm) of it from the printer –
then proceed according to your application:
Media

To wind onto a Media Core –
Follow the directional arrows on the Core
Adapter and wrap the Media in a
counterclockwise direction around the
Media Core then secure the leading edge
using Tape. Rotate the Hub by hand to
take up any slack in the media. There
should be at least 2 or 3 full wraps of the
media on the empty core before starting
printing to ensure tight rewinded rolls.
Media
(Labels & Liner)
Tape
Media
Core
Core
Adapter

To wind onto the Rewinder Hub –
Remove the labels from the extended
portion of media and crease the leading
edge of this Liner Material.
Wrap the Liner Material in a
counterclockwise direction around the
Rewinder Hub and insert the creased
leading edge into one of its Slots. Insert
the Media Clasp (Item ) into the Slot
over the creased leading edge of the
Liner Material and around the Rewinder
Hub.
Rewinder
Hub
Media
Clasp
Liner
Material
Slots
creased
leading edge