Datamax-O'Neil H-Class Peel & Present Option - Manual (Page 5)

3
A) Load Media (see the Operator’s Manual for
details). Extend 20 inches (50 cm) of Media
from the printer.
B) Remove the labels from this extended portion
of media, leaving only the Backing Material.
Crease the leading edge of this Backing
Material and route it behind the Present
Sensor (on the Peel & Present Assembly).
Present
Sensor
Backing Material
Media
Supply
Hub
C) Route the Backing Material under the
Assist Roller and the Internal Rewinder.
Assist Roller
Internal
Rewinder
Backing
Material
D) Wrap the Backing Material in a
counterclockwise direction around the
Rewinder Hub and insert the creased
leading edge into one of its Slots. Insert the
Media Clasp (Item ) into the Slot over the
creased leading edge of the Backing
Material and around the Rewinder Hub.
Rewinder
Hub
Media
Clasp
Backing
Material
Slots
creased
leading edge
E) Close the Access Cover, plug the power cord into the AC Receptacle, and turn ‘On’ the Power
Switch.