Datamax-O'Neil H-Class Cutter Option - Manual (Page 6)

4
Step 4: Configuring the Printer
While the Cutter option is a plug and play device, this step may be necessary if the printer’s default
configuration has been changed. Follow the steps below to configure the printer:

Note: In the following procedure, consult the Operator’s Manual for detailed front panel instructions.
A) Press the MENU Button on the printer’s front panel.
B) Using the DOWN Button, scroll to PRINTER OPTIONS then press the RIGHT Button.
C) Using the DOWN Button, scroll to CUTTER then press the ENTER Key.
D) Using the DOWN Button, scroll to AUTO then press the ENTER Key.
E) Press the EXIT Key then, at the SAVE CHANGES? prompt, select YES.
F) Turn the Power Switch ‘Off’ and ‘On’ to reset the printer and complete the configuration.