Datamax-O'Neil PrintPAD AN-07 - Manual (Page 3)

And just as the field can be modified, the entire image can be modified through “Global Parameters”. The image can be
rotated 90 degrees (landscape) so that the left hand edge of the image emerges from the printer first. And you can
specify that you are using media with QMARKs or Interlabel gap (depending upon the printer), so the printer will stop
properly and automatically align with each label printed.
GLOBAL PARAMETERS
BACK nnn Sets the printer to backup nnn dotlines before beginning to print
JOBSTATUS Turns Job Status Reporting ON for an Easy Print Job (see separate Job Status Reporting
document). Version 6.68 and later
QSTOP nnn Sets the printer to stop nnn dotlines after a QMARK is detected on the TOP of the media. This
parameter is for printers with a sensor for the TOP of the media (MF2, MF3, original 2t, 4t). If
specified as part of a print job, this will override the configured values. Each dotline is .005” and
typical value is around 95-125, but may be more or less depending upon the location of the QMARK.
QSTOPB nnn Sets the printer to stop nnn dotlines after a QMARK is detected on the BACK of the media. This
parameter is for printers with a sensor for the back of the media (LP3). If specified as part of a print
job, this will override the configured values. Each dotline is .005” and typical value is around 95-125,
but may be more or less depending upon the location of the QMARK. Each dotline is .005” and
typical value is around 95-125, but may be more or less depending upon the location of the QMARK.
QSTOP nnn Sets the printer to stop nnn dotlines after a QMARK is detected on the TOP of the media. This
parameter is for printers with a sensor for the TOP of the media (MF2, MF3, original 2t, 4t). If
specified as part of a print job, this will override the configured values. Each dotline is .005” and
typical value is around 95-125, but may be more or less depending upon the location of the QMARK.
QSTOPB nnn Sets the printer to stop nnn dotlines after a QMARK is detected on the BACK of the media. This
parameter is for printers with a sensor for the back of the media (LP3). If specified as part of a print
job, this will override the configured values. Each dotline is .005” and typical value is around 95-125,
but may be more or less depending upon the location of the QMARK. Each dotline is .005” and
typical value is around 95-125, but may be more or less depending upon the location of the QMARK.
QSTOPG nnn Sets the printer to stop nnn dotlines after an interlabel gap is detected. This parameter is for printers
with sensors for the TOP and BACK of the media (LP3). If specified as part a print job, this will
override the configured values. Each dotline is .005” and typical value is around 95-125, but may be
more or less.