Datamax-O'Neil M-Class Mark II Peel & Present Option - Manual (Page 10)

8
 Remove Upper Roller Shaft and associated
Rollers.
 Clean
all surfaces of the Rollers and the Upper
Roller Shaft. Isopropyl Alcohol can be used,
for heavy or stubborn deposits WD-40
or an
adhesive remover can be used. Be sure all the
ridges on the rollers are free of debris.
 Re-assemble the Upper Roller Shaft, Rollers,
and C-Clip into the Peel Mechanism Assembly.
Rollers
Upper Roller
Shaft
Lower Rollers:
 Remove the Peel Mechanism from the printer.
Press in on the Latch and allow the Front Cover
to swing open.
 Push in on the Tab as shown, repeat for the
other side and then remove the entire Lower
Roller Assembly.
Lower Roller
Assembly
Push in on Tab
 Remove Lower Roller Shaft and associated
Rollers. Note the order of the Rollers as they
are removed, they must be re-installed in the
same order.
 Clean
all surfaces of the Rollers and the Lower
Roller Shaft. Isopropyl Alcohol can be used,
for heavy or stubborn deposits WD-40
or an
adhesive remover can be used. Be sure all the
ridges on the rollers are free of debris.
 Re-assemble the Lower Roller Shaft and
Rollers. Reinstall the assembly into the Peel
Mechanism Assembly
Lower Roller
Shaft